selecure uvm1 plus

Technical data

UV MODULE SELECURE UVM 1 PLUS

Available lamp length                             13 - 90.5 inches 

Available lamp power.                             From 40 to 120 W/cm

Cooling type                                              Air

Power supply type                                   Electronic

Functioning Mode                                   direct - cold - standby 

This is the state of the art advanced technology in the FIeld of photo-polymerization. 

 

The traditional ultraviolet sources produce an intense infrared radiation that causes overheating of the irradiated substrate.

 

Thanks to a device designed and perfected in Superfici laboratories, it is able to filter the emitted UV radiation, eliminating most of the infrared component. The result is a cold UV light that can be used with any type of heat-sensitive material, the system is called Coldcure.

•    DIRECT IRRADIATION
on the surface to be cured. The reflector is oriented downwards. In this position we have the maximum of the specific power on the work-piece; all UV and IR range of the emission of the lamps reach the work-piece.

 

•    COLDCURE POSITION
the radiating source is oriented towards a selective surface, which reflects only the UV range of the lamps emission, avoiding to transfer on the work-piece the heat generated by the IR range, thus obtaining a Cold polymerisation.

 

•    STAND BY POSITION
this position enters automatically whenever there is a conveyor stop. The lamp power supply decreases to 50% or to other previously fixed values.